Ghosting rarely means a dead printhead. It shows up as a second edge on text and lines, and a clean nozzle check does not rule it out. Read the offset direction
Read MoreThe i1600 and the i3200 share one block, one print width and one droplet set. The only real change is nozzle rows, four against eight, so throughput depends on
Read MoreThe counter on an HP Latex panel measures ink consumed, not output still available. Read the head counter, the printed nozzle check, and the maintenance cartrid
Read MoreUV DTF transfers fail in three separate places: the print, the lamination, and the hand application. This guide shows how to name the symptom first, why the A f
Read MoreCrooked prints on a roll fed machine come from three places: media pulled at an angle, media gripped unevenly, or media not held flat. Mark both edges at one me
Read MoreA wide format ink pump fails slowly, and by the time the nozzles go quiet most shops have already ordered a printhead. One cleaning cycle with your eyes on the
Read MoreThe panel code is a location, not a diagnosis. Pull the error history first, sort the codes by when they appeared, and read the subsystem name rather than the n
Read MoreThe CR motor is the part most shops blame and the part that is usually fine. Stretched belts, glazed pulleys, dry rails and dragging ink tubes cause most carria
Read MoreA new printhead that passes one nozzle check and fails by the second production hour is almost never a bad head. This five stage commissioning sequence covers d
Read MoreBanding is a measurement, not a mystery. Measure the distance between consecutive bands, compare that pitch with the feed step of your pass mode, and the machin
Read MoreBanding that starts halfway through a roll rarely means a dead printhead. Measure the interval between bands first, then work the checks in cost order: nozzle p
Read MoreWe use cookies to keep this site working and, with your consent, to measure traffic. You can change your choice any time. Cookie Policy Privacy Policy
