No products matched your keyword.
Try browsing the categories or searching a part number.
The i1600 and the i3200 share one block, one print width and one droplet set. The only real change is nozzle rows, four against eight, so throughput depends on
Read MoreA printhead cable with a broken conductor looks healthy, so judge by behavior instead of appearance. Print the same short strip at two carriage positions and co
Read MoreCrooked prints on a roll fed machine come from three places: media pulled at an angle, media gripped unevenly, or media not held flat. Mark both edges at one me
Read MoreThree heater zones on a Roland XF-640 do three different jobs, and the setpoint ranges are narrow on purpose. Here is what the preheater, the print heater and t
Read MoreInk on the printhead nose is usually not a dead printhead. Clean the nozzle plate, park the carriage, and then read when the drip comes back: while idle, mid pr
Read MoreThe panel code is a location, not a diagnosis. Pull the error history first, sort the codes by when they appeared, and read the subsystem name rather than the n
Read MoreThe CR motor is the part most shops blame and the part that is usually fine. Stretched belts, glazed pulleys, dry rails and dragging ink tubes cause most carria
Read MoreDry shop air raises the surface resistance of film, banner and coated stock, and the charge it builds pulls satellite droplets off course onto the nozzle plate
Read MoreNine components sit between an ink bottle and a sheet of DTF film, and the white channel touches every one. This walk through the ink path names each consumable
Read MoreFollow one JV300 through a working day and the real consumables map writes itself: the moments when a part decides whether the shift finishes on time. Here is w
Read MoreA dirty encoder strip mimics a dying printhead, a slipping belt, and a bad carriage board, which is why shops replace the wrong part first. Here is the cleaning
Read MoreMost shops blame the powder for a transfer that peels, then buy a different powder and get the same result. This guide explains what mesh size really controls,
Read MoreWhite ink settles in hours, not days, which is why Monday morning underbases come out gray. This guide covers the circulation routine that keeps titanium dioxid
Read MoreCount the parts between the ink bag and the nozzle plate and you find ten components, eight of which can destroy the most expensive one in the machine. These fi
Read MoreBanding is a measurement, not a mystery. Measure the distance between consecutive bands, compare that pitch with the feed step of your pass mode, and the machin
Read MoreBanding that starts halfway through a roll rarely means a dead printhead. Measure the interval between bands first, then work the checks in cost order: nozzle p
Read MoreWe use cookies to keep this site working and, with your consent, to measure traffic. You can change your choice any time. Cookie Policy Privacy Policy