Half a black row missing on the morning nozzle check is not automatically a dead printhead. Three test sheets, read in the right order, separate air in the ink
Read MoreUV DTF transfers fail in three separate places: the print, the lamination, and the hand application. This guide shows how to name the symptom first, why the A f
Read MoreAn S80600 has ten ink slots but only nine hold colors. The tenth takes either a White or a Metallic Silver cartridge, never both. Here is how the slot map diffe
Read MoreKyocera KJ4A and KJ4B printheads share the same footprint, nozzle count and width, but one is built for UV ink and one for water-based. This guide covers how to
Read MoreCrooked prints on a roll fed machine come from three places: media pulled at an angle, media gripped unevenly, or media not held flat. Mark both edges at one me
Read MoreThree heater zones on a Roland XF-640 do three different jobs, and the setpoint ranges are narrow on purpose. Here is what the preheater, the print heater and t
Read MoreA wide format ink pump fails slowly, and by the time the nozzles go quiet most shops have already ordered a printhead. One cleaning cycle with your eyes on the
Read MoreThe CR motor is the part most shops blame and the part that is usually fine. Stretched belts, glazed pulleys, dry rails and dragging ink tubes cause most carria
Read MoreDry shop air raises the surface resistance of film, banner and coated stock, and the charge it builds pulls satellite droplets off course onto the nozzle plate
Read MoreA new printhead that passes one nozzle check and fails by the second production hour is almost never a bad head. This five stage commissioning sequence covers d
Read MoreNine components sit between an ink bottle and a sheet of DTF film, and the white channel touches every one. This walk through the ink path names each consumable
Read MoreA dirty encoder strip mimics a dying printhead, a slipping belt, and a bad carriage board, which is why shops replace the wrong part first. Here is the cleaning
Read MoreOne transfer, two fabrics, two results. The press settings that work on cotton rarely survive the trip to polyester. This guide swaps the usual chart for a ladd
Read MoreMost shops blame the powder for a transfer that peels, then buy a different powder and get the same result. This guide explains what mesh size really controls,
Read MoreA failing cap and a failing printhead look identical on a nozzle check, which is why so many good heads get replaced for no reason. This guide gives the daily w
Read MoreA damper, a cap top, and a wiper rarely fail loudly. They add a little variability to every print until that variability becomes your normal output. Follow one
Read MoreWe use cookies to keep this site working and, with your consent, to measure traffic. You can change your choice any time. Cookie Policy Privacy Policy
